Cm-1000-M2St2 Media Converter

CM-1000-M2ST2 Media Converter

Yes

Perle MCR1900 Media Converter Chassis

Transceiver/Media Converter

2

50/125 µm, 62.5/125 µm

Duplex

1.24 Mile

1000Base-LX, 1000Base-T

1

Internal

Yes

1

5.28 oz

EN55024

minimum range of -25° C to 70° C (-13° F to 158° F)

1.5kv

u003c10-12

Full (Default-Up)- The media converter will advertise Full Duplex Capable, Half Duplex Capable; AUTO (Down)-The Media converter will advertise Full Duplex Not Capable, Half Duplex Capable.

5% to 90% non-condensing

Auto (default) enable management module to overwrite hardware switch settings Switch - Use on-board DIP switches

FCC Part 15 Class A, EN55022 Class A

EN 60825-1:2007

The media converter can perform a loopback on the 1000Base-X fiber interface; Disabled (Default - Up); Enabled- The 1000Base-X receiver is looped to the 1000Base-X transmitter. The 1000Base-T transmitter is taken off the interface.

When Fiber Auto Negotiation is disabled Pause should only be enabled when all devices connected to the media converter support pause; Enabled(Default)- The Media converter will advertise Pause capable, Asymmetric pause not needed during Auto-Negotiation; Disabled- The Media converter will advertise that it does not have Pause capability during Auto-Negotiation.

Enabled (Default - Up)- In this mode the 1000Base-X and the 1000Base-T will negotiate to the HCD of the two link partners. The 1000Base-X will link up after the negotiation is completed and the 1000Base-T has linked up; Disabled- The 1000Base-X will not use auto negotiation. The 1000Base-T will negotiate to the HCD of the Switch settings and the link partner.

This green LED is turned on when power is applied to the media converter. Otherwise it is off. The LED will blink when in Loopback test mode.

This green LED is operational only when power is applied. The LED is on when the 1000Base-X link is on and flashes with a 50% duty cycle when data is received. The LED will slow blink when the 1000Base-X interface has been taken down as a result of a fault on the 1000Base-T interface.

The Fiber Fault Alert switch has meaning when Auto-Negotiation is disabled; Enabled (Default - Up); When the 1000Base-X receiver is off the 1000Base-X transmitter is turned off. Periodically the 1000Base-X receiver will be turned on for a short period to allow the condition to clear if the 1000Base-X link partner is using a similar feature; Disabled (Down)

32 pin DIN 41612 / IEC 60603-2 Type B/2 Male. Fist make, last break for ground and power

Captive thumb screws enable fast insertion and removal. Can be further tighten with a screwdriver.

0° C to 50° C (32° F to 122° F)

10.2

3

RJ45 connector, 4 pair CAT 5 UTP cable or cable

This green LED is operational only when power is applied. The LED i on when the 1000Base-T link is on and flashes with a 50% duty cycle when data is received. The LED will slow blink when the 1000Base-T interface has been taken down as a result of a fault on the 1000Base-T interface.

UL 60950-1

5% to 95% non-condensing

Up to 3,048 meters (10,000 feet)

Canada

1